EN 13611:202x, Clause 1 applies with the following modification and addition:
Modification:
The 1st paragraph of EN 13611:202x, Clause 1 is replaced by:
This document specifies the safety, design, construction, and performance requirements and testing for
automatic shut-off valves for burners and appliances burning one or more gaseous fuels, hereafter
referred to as “valves”.
This document is applicable to valves with declared maximum inlet pressures of more than 500 kPa and
up to and including 6 300 kPa and of nominal connection sizes up to and including DN 250.
Addition:
This document is applicable to:
— electrically actuated valves;
— valves actuated by fluids including the pilot valves for these fluids if actuated electrically and
including release valves, but not to any external electrical devices for switching the actuating energy;
— valves where the flow rate is controlled by external electrical signals proportional to the applied
signal;
— valves fitted with closed position indicator switches.
This document is not applicable to valves specifically designed for use in transmission and distribution
networks.
The 4th paragraph of EN 13611:202x, Clause 1 is removed.
Registration number (WIID)
84374
Scope
EN 13611:202x, Clause 1 applies with the following modification and addition:
Modification:
The 1st paragraph of EN 13611:202x, Clause 1 is replaced by:
This document specifies the safety, design, construction, and performance requirements and testing for
automatic shut-off valves for burners and appliances burning one or more gaseous fuels, hereafter
referred to as “valves”.
This document is applicable to valves with declared maximum inlet pressures of more than 500 kPa and
up to and including 6 300 kPa and of nominal connection sizes up to and including DN 250.
Addition:
This document is applicable to:
— electrically actuated valves;
— valves actuated by fluids including the pilot valves for these fluids if actuated electrically and
including release valves, but not to any external electrical devices for switching the actuating energy;
— valves where the flow rate is controlled by external electrical signals proportional to the applied
signal;
— valves fitted with closed position indicator switches.
This document is not applicable to valves specifically designed for use in transmission and distribution
networks.
The 4th paragraph of EN 13611:202x, Clause 1 is removed.
