This European Standard specifies requirements, assessment methods, compliance criteria and a designation system for threaded fittings. These threaded ends exist with metallic and with non-metallic sealing elements for the purposes of joining with tubes, pipes, fittings or valves, the threaded ends have a size range from 3,175 mm (1/8”) to 101,6 mm (4”). The threaded fittings are designed for a service lifetime up to fifty years.
This European Standard applies to fittings made of materials listed in CEN/TS 13388.
Threaded fittings may also have flanged end connections according to EN 1092-3.
Threaded fittings may also have a plated or other decorative surface coating.
Products covered by this standard are intended to be used in:
a) liquid applications:
hot or cold or combined hot and cold water systems;
heating and cooling systems;
drainage systems;
sprinkler systems.
b) gas applications:
natural gas and liquefied petroleum gas systems with a maximum operating pressure less than or equal to 5 bar;
compressed air.
Operating temperatures and pressures for assembled joints shall not exceed the values in Annex A.
Registration number (WIID)
61367
Scope
This European Standard specifies requirements, assessment methods, compliance criteria and a designation system for threaded fittings. These threaded ends exist with metallic and with non-metallic sealing elements for the purposes of joining with tubes, pipes, fittings or valves, the threaded ends have a size range from 3,175 mm (1/8”) to 101,6 mm (4”). The threaded fittings are designed for a service lifetime up to fifty years.
This European Standard applies to fittings made of materials listed in CEN/TS 13388.
Threaded fittings may also have flanged end connections according to EN 1092-3.
Threaded fittings may also have a plated or other decorative surface coating.
Products covered by this standard are intended to be used in:
a) liquid applications:
hot or cold or combined hot and cold water systems;
heating and cooling systems;
drainage systems;
sprinkler systems.
b) gas applications:
natural gas and liquefied petroleum gas systems with a maximum operating pressure less than or equal to 5 bar;
compressed air.
Operating temperatures and pressures for assembled joints shall not exceed the values in Annex A.
