ISO/TC 118/SC 3
| Project No. | ISO 8662-11:1999 |
|---|---|
| Title | <p>This part of ISO 8662 specifies a laboratory method for measuring the single-event vibration at the handle of</p> <p>fastener driving tools, where a single event is a mechanical shock or a series of individual shocks at intervals longer</p> <p>than 0,2 s. It is a type test procedure for establishing the vibration value in the handle of a hand-held power tool</p> <p>operating under a specified load.</p> <p>NOTE Fastener driving tools are also referred to as nailers, pinners, tackers and staplers.</p> <p>For fastener driving tools to which this part of ISO 8662 is applicable, the power required for operation can be</p> <p>supplied by pneumatic or hydraulic pressure, combustible gases in an internal combustion engine or from spring</p> <p>tension. The fastener driving tools may be actuated by single actuation, contact actuation or continuous actuation.</p> <p>This part of ISO 8662 is applicable to fasteners comprising nails, staples, pins, corrugated fasteners, screws used</p> <p>as nails, dowels, sleeves, cable collars and base supports.</p> <p>It is intended that the results of application of this part of ISO 8662 be used for comparing different models of the</p> <p>same type of power tool.</p> |
| Registration number (WIID) | 23170 |
| Scope | <p>This part of ISO 8662 specifies a laboratory method for measuring the single-event vibration at the handle of</p> <p>fastener driving tools, where a single event is a mechanical shock or a series of individual shocks at intervals longer</p> <p>than 0,2 s. It is a type test procedure for establishing the vibration value in the handle of a hand-held power tool</p> <p>operating under a specified load.</p> <p>NOTE Fastener driving tools are also referred to as nailers, pinners, tackers and staplers.</p> <p>For fastener driving tools to which this part of ISO 8662 is applicable, the power required for operation can be</p> <p>supplied by pneumatic or hydraulic pressure, combustible gases in an internal combustion engine or from spring</p> <p>tension. The fastener driving tools may be actuated by single actuation, contact actuation or continuous actuation.</p> <p>This part of ISO 8662 is applicable to fasteners comprising nails, staples, pins, corrugated fasteners, screws used</p> <p>as nails, dowels, sleeves, cable collars and base supports.</p> <p>It is intended that the results of application of this part of ISO 8662 be used for comparing different models of the</p> <p>same type of power tool.</p> |
| Status | Atcelts |
| ICS group | 13.160 25.140.10 |