ISO/TC 118/SC 3
| Project No. | ISO 28927-1:2019 |
|---|---|
| Title | <p>This document specifies a laboratory method for measuring hand-transmitted vibration emission at the handles of hand-held power-driven angle and vertical grinders. It is a type-test procedure for establishing the magnitude of vibration in the gripping areas of a machine fitted with a specified test wheel and run under no‑load conditions. The method has been established for surface grinding tasks only. Cutting and sanding generally create lower vibrations. It is intended that the results be used to compare different models of the same type of machine.</p> <p>This document is applicable to hand-held machines (see Clause 5), driven pneumatically or by other means, intended for grinding, cutting-off and rough sanding, with bonded, coated and super-abrasive products and with wire brushes for use on all kinds of materials. It is not applicable to die grinders or straight grinders.</p> <p>NOTE To avoid confusion with the terms "power tool" and "inserted tool", <i>machine</i> is used for the former throughout this document.</p> |
| Registration number (WIID) | 78207 |
| Scope | <p>This document specifies a laboratory method for measuring hand-transmitted vibration emission at the handles of hand-held power-driven angle and vertical grinders. It is a type-test procedure for establishing the magnitude of vibration in the gripping areas of a machine fitted with a specified test wheel and run under no‑load conditions. The method has been established for surface grinding tasks only. Cutting and sanding generally create lower vibrations. It is intended that the results be used to compare different models of the same type of machine.</p> <p>This document is applicable to hand-held machines (see Clause 5), driven pneumatically or by other means, intended for grinding, cutting-off and rough sanding, with bonded, coated and super-abrasive products and with wire brushes for use on all kinds of materials. It is not applicable to die grinders or straight grinders.</p> <p>NOTE To avoid confusion with the terms "power tool" and "inserted tool", <i>machine</i> is used for the former throughout this document.</p> |
| Status | Standarts spēkā |
| ICS group | 13.160 25.140.10 |