CEN/TC 155
| Registration number (WIID) | Project No. | Title | Status |
|---|---|---|---|
| 6229 | - | Plastics piping systems for buried ducting - Polypropylene (PP) - Part 2: Pipes | Izstrādē |
| 6295 | - | Plastics piping systems for industrial applications - Unplasticized, chlorinated and high impact poly(vinyl chloride) (PVC-U, PVC-C and PVC-HI) - Part 3: Assessment of conformity | Izstrādē |
| 6211 | - | Plastics piping systems for hot and cold domestic water supply, floor heating and central heating - Polyethylene (PE) - Part 6: Recommended practice for installation | Izstrādē |
| 6303 | - | Plastics piping systems for industrial applications - Glass-reinforced thermosetting plastics (GRP) based on various types of resins - Above and below ground assembled from custom made components - Part 1: General | Izstrādē |
| 6300 | - | Plastics piping systems for industrial applications - Glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) - Below ground assembled from standard components - Part 5: Fitness for purpose of the system | Izstrādē |
| 80460 | - | Plastics piping systems for non-pressure underground drains and sewers for transport, infiltration and exfiltration of surface water - Unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) —Specification for pipes, fittings and the system. | Izstrādē |
| 6330 | - | Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes - Determination of the long-term specific ring creep stiffness under wet conditions and calculation of the wet creep factor (ISO/DIS 10468:1999) | Izstrādē |
| 6273 | - | Plastics piping systems for renovation of underground water supply networks - Part 3: Lining with close-fit pipes | Izstrādē |
| 20878 | - | Plastics piping systems for drainage and sewerage - Glass reinforced thermosetting plastics (GRP) based on polyester resin (UP) - Manholes, inspections chambers and ancillary fittings | Izstrādē |
| 33039 | - | Plastics piping systems for soil and waste discharge (low and high temperature) within the building structure - Polypropylene with mineral modifier(s) (PP-MD) - Part 1: Specifications for pipes, fittings and the system | Izstrādē |
Displaying 141-150 of 1488 results.