CEN/TC 155
| Registration number (WIID) | Project No. | Title | Status |
|---|---|---|---|
| 35323 | EN ISO 11296-1:2011 | Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks - Part 1: General (ISO 11296-1:2009) | Atcelts |
| 24014 | CEN/TS 1852-3:2003/A1:2005 | Plastics piping systems for non-pressure underground drainage and sewerage - Polypropylene (PP) - Part 3: Guidance for installation | Atcelts |
| 6057 | EN 715:1994 | Thermoplastics piping systems - End-load bearing joints between small diameter pressure pipes and fittings - Test method for leaktightness under internal water pressure, including end thrust | Atcelts |
| 6055 | EN 803:1994 | Plastics piping systems - Injection-moulded thermoplastics fittings for elastic sealing ring type joints for pressure piping - Test method for resistance to a short-term internal pressure without end thrust | Atcelts |
| 24013 | EN ISO 9969:2007 | Thermoplastics pipes - Determination of ring stiffness (ISO 9969:2007) | Atcelts |
| 20864 | EN ISO 6259-1:2001 | Thermoplastics pipes - Determination of tensile properties - Part 1: General test method (ISO 6259-1:1997) | Atcelts |
| 6198 | EN 12106:1997 | Plastics piping systems - Polyethylene (PE) pipes - Test method for the resistance to internal pressure after application of squeeze-off | Atcelts |
| 61554 | CEN/TS 14758-2:2016 | Plastics piping systems for non-pressure underground drainage and sewerage - Polypropylene with mineral modifiers (PP-MD) - Part 2: Guidance for the assessment of conformity | Atcelts |
| 6198 | LVS EN 12106:2000 | Plastics piping systems - Polyethylene (PE) pipes - Test method for the resistance to internal pressure after application of squeeze-off | Atcelts |
| 61554 | LVS CEN/TS 14758-2:2016 | Plastics piping systems for non-pressure underground drainage and sewerage - Polypropylene with mineral modifiers (PP-MD) - Part 2: Guidance for the assessment of conformity | Atcelts |
Displaying 901-910 of 1434 results.