CEN/TC 249
| Registration number (WIID) | Project No. | Title | Status |
|---|---|---|---|
| 12062 | EN ISO 2554:1998 | Plastics - Unsaturated polyester resins - Determination of hydroxyl value (ISO 2554:1997) | Izstrādē |
| 12170 | prEN ISO 15527 | Compression moulded sheets of polyethylene (PE-UHMW, PE-HMW, PE-HD) - Requirements and test methods (ISO/DIS 15527:1998) | Izstrādē |
| 21780 | EN ISO 15106-1:2005 | Plastics - Film and sheeting - Determination of water vapour transmission rate - Part 1: Humidity detection sensor method (ISO 15106-1:2003) | Izstrādē |
| 30276 | prEN ISO 294-4 rev | Plastics - Injection moulding of test specimens of thermoplastic materials - Part 4: Determination of moulding shrinkage | Izstrādē |
| 12117 | EN ISO 14130:1997 | Fibre-reinforced plastic composites - Determination of apparent interlaminar shear strength by short-beam method (ISO 14130:1997) | Izstrādē |
| 22654 | - | Procedure for validating the recycled content in products | Izstrādē |
| 27168 | EN ISO 2439:2008 | Flexible cellular polymeric materials - Determination of hardness (indentation technique) (ISO/FDIS 2439:2008) | Izstrādē |
| 12234 | EN ISO 14527-1:1999 | Plastics - Urea-formaldehyde and urea/melamine-formaldehyde powder moulding compounds (UF- and UF/MF-PMCs) - Part 1: Designation system and basis for specifications (ISO 14527-1:1999) | Izstrādē |
| 36073 | EN 13341:2005+A1:2011 | Static thermoplastic tanks for above ground storage of domestic heating oils, kerosene and diesel fuels - Blow moulded and rotationally moulded polyethylene tanks and rotationally moulded tanks made of anionically polymerized polyamide 6 - Requirements and test methods | Izstrādē |
| 30254 | EN ISO 294-1:2017 | Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding of multipurpose and bar test specimens (ISO/DIS 294-1:2016) | Izstrādē |
Displaying 201-210 of 2304 results.