ISO/TC 213
| Registration number (WIID) | Project No. | Title | Status |
|---|---|---|---|
| 10136 | ISO 4292:1985 | Methods for the assessment of departure from roundness — Measurement by two- and three-point methods | Atcelts |
| 4346 | ISO 370:1975 | Toleranced dimensions — Conversion from inches into millimetres and vice versa | Atcelts |
| 63512 | ISO 1101:2012/Cor 1:2013 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out — Technical Corrigendum 1 | Atcelts |
| 54013 | ISO 14405-2:2011 | Geometrical product specifications (GPS) — Dimensional tolerancing — Part 2: Dimensions other than linear sizes | Atcelts |
| 39419 | ISO 12179:2000/Cor 1:2003 | Geometrical Product Specifications (GPS) — Surface texture: Profile method — Calibration of contact (stylus) instruments — Technical Corrigendum 1 | Atcelts |
| 28069 | ISO 2538:1998 | Geometrical Product Specifications (GPS) — Series of angles and slopes on prisms | Atcelts |
| 1147 | ISO 1101:2004 | Geometrical Product Specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out | Atcelts |
| 33756 | ISO/TS 17450-2:2002 | Geometrical product specifications (GPS) — General concepts — Part 2: Basic tenets, specifications, operators and uncertainties | Atcelts |
| 29876 | ISO 11562:1996/Cor 1:1998 | Geometrical Product Specifications (GPS) — Surface texture: Profile method — Metrological characteristics of phase correct filters — Technical Corrigendum 1 | Atcelts |
| 50177 | ISO/TS 16610-30:2009 | Geometrical product specifications (GPS) — Filtration — Part 30: Robust profile filters: Basic concepts | Atcelts |
Displaying 181-190 of 489 results.
