ISO/TC 213
| Registration number (WIID) | Project No. | Title | Status |
|---|---|---|---|
| 59490 | ISO 1101:2012 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out | Atcelts |
| 28068 | ISO 1119:1998 | Geometrical Product Specifications (GPS) — Series of conical tapers and taper angles | Atcelts |
| 42975 | ISO/TS 16610-41:2006 | Geometrical product specifications (GPS) — Filtration — Part 41: Morphological profile filters: Disk and horizontal line-segment filters | Atcelts |
| 7619 | ISO 2632-1:1985 | Roughness comparison specimens | Atcelts |
| 60774 | ISO 8062-4:2017 | Geometrical product specifications (GPS) — Dimensional and geometrical tolerances for moulded parts — Part 4: General tolerances for castings using profile tolerancing in a general datum system | Atcelts |
| 7747 | ISO 2768:1973 | Permissible machining variations in dimensions without tolerance indication | Atcelts |
| 56784 | ISO 25178-71:2012 | Geometrical product specifications (GPS) — Surface texture: Areal — Part 71: Software measurement standards | Atcelts |
| 56227 | ISO/TS 12781-2:2003/Cor 1:2010 | Geometrical Product Specifications (GPS) — Flatness — Part 2: Specification operators — Technical Corrigendum 1 | Atcelts |
| 53975 | ISO 25178-605:2014 | Geometrical product specifications (GPS) — Surface texture: Areal — Part 605: Nominal characteristics of non-contact (point autofocus probe) instruments | Atcelts |
| 10136 | ISO 4292:1985 | Methods for the assessment of departure from roundness — Measurement by two- and three-point methods | Atcelts |
Displaying 191-200 of 479 results.