ISO/TC 213
| Registration number (WIID) | Project No. | Title | Status |
|---|---|---|---|
| 29649 | ISO/WD 1829 | Geometrical product specifications (GPS) — Selection of tolerance zones for general purposes | Izstrādē |
| 1952 | ISO/WD 1880 | Instruments for the measurement of surface roughness by the profile method — Contact (stylus) instruments of progressive profile transformation — Profile recording instruments | Izstrādē |
| 26612 | ISO/WD 2632-1 | Roughness comparison specimens — Part 1: Turned, ground, bored, milled, shaped and planed | Izstrādē |
| 2112 | ISO/WD 2632-3 | Roughness comparison specimens — Part 3: Cast surfaces | Izstrādē |
| 39929 | ISO/WD 4287 | Geometrical Product Specifications (GPS) — Surface texture: Profile method — Terms, definitions and surface texture parameters | Izstrādē |
| 21979 | ISO/WD 4291 | Methods for the assessement of departure from roundness — Measurement of variations in radius | Izstrādē |
| 26614 | ISO/WD 4292 | Geometrical Product Specifications (GPS) — Surface texture: Profile method — Departure from roundness — Measurement by two- and three-point methods | Izstrādē |
| 21290 | ISO/WD 468 | Surface roughness — Parameters, their values and general rules for specifying requirements | Izstrādē |
| 29648 | ISO/WD 8015 | Geometrical product specifications (GPS) — Fundamental tolerancing principle | Izstrādē |
Displaying 471-479 of 479 results.