ISO/TC 213
| Registration number (WIID) | Project No. | Title | Status |
|---|---|---|---|
| 30389 | ISO/DTS 16610-29 | Geometrical product specifications (GPS) — Filtration — Part 29: Linear profile filters: Spline wavelets | Izstrādē |
| 26181 | ISO/PWI 14995-1 | Geometrical Product Specification (GPS) — Textual equivalents for graphical symbols — Part 1: Dimensional and geometrical tolerancing | Izstrādē |
| 44236 | ISO/NP 27607 | Geometrical product specifications and verification (GPS) — Definition of competences for persons executing measurements using a CMM | Izstrādē |
| 28093 | ISO/DIS 8062-2 | Geometrical Product Specifications (GPS) — Dimensional and geometrical tolerances for moulded parts — Part 2: General dimensional and geometrical tolerances and machining allowances for castings | Izstrādē |
| 6630 | ISO/DIS 1938 | Geometrical Product Specifications (GPS) — Inspection of plain workpieces by plain limit gauges | Izstrādē |
| 62307 | ISO 4287:1997/DAmd 2 | Geometrical Product Specifications (GPS) — Surface texture: Profile method — Terms, definitions and surface texture parameters — Amendment 2: Parameters Xsm and Xc | Izstrādē |
| 2112 | ISO/WD 2632-3 | Roughness comparison specimens — Part 3: Cast surfaces | Izstrādē |
| 17220 | ISO/DIS 9493.2 | Geometrical product specifications (GPS) — Dimensional measuring instruments: Dial test indicators (lever type) — Design and metrological requirements | Izstrādē |
| 32397 | ISO/NP 13225 | Geometrical Product Specifications (GPS) — Dimensional measuring instruments: Height gauges — Design and metrological requirements | Izstrādē |
| 63654 | ISO/PWI 10360-11 | Geometrical product specifications (GPS) — Acceptance and reverification tests for coordinate measuring systems (CMS) — Part 11: Computed tomography | Izstrādē |
Displaying 81-90 of 479 results.