ISO/TC 138/SC 1/WG 6
| Projekta Nr. | ISO 13259:2020 |
|---|---|
| Nosaukums | <p>This document specifies a test method for determining the leaktightness of elastomeric sealing ring type joints for buried thermoplastics non-pressure piping systems.</p> <p>Unless otherwise specified in the referring standard, the tests are carried out at the following basic test pressures:</p> <p>— <i>p</i><sub>1</sub>: internal negative air pressure (partial vacuum);</p> <p>— <i>p</i><sub>2</sub>: a low internal hydrostatic pressure;</p> <p>— <i>p</i><sub>3</sub>: a higher internal hydrostatic pressure.</p> <p>It also describes the following four test conditions under which the tests are performed:</p> <p>a) Condition A: without any additional diametric or angular deflection;</p> <p>b) Condition B: with diametric deflection;</p> <p>c) Condition C: with angular deflection;</p> <p>d) Condition D: with simultaneous angular and diametric deflection.</p> <p>The applicable selection of the test pressure(s) and the test condition(s) is/are specified in the referring standard.</p> |
| Reģistrācijas numurs (WIID) | 80706 |
| Darbības sfēra | <p>This document specifies a test method for determining the leaktightness of elastomeric sealing ring type joints for buried thermoplastics non-pressure piping systems.</p> <p>Unless otherwise specified in the referring standard, the tests are carried out at the following basic test pressures:</p> <p>— <i>p</i><sub>1</sub>: internal negative air pressure (partial vacuum);</p> <p>— <i>p</i><sub>2</sub>: a low internal hydrostatic pressure;</p> <p>— <i>p</i><sub>3</sub>: a higher internal hydrostatic pressure.</p> <p>It also describes the following four test conditions under which the tests are performed:</p> <p>a) Condition A: without any additional diametric or angular deflection;</p> <p>b) Condition B: with diametric deflection;</p> <p>c) Condition C: with angular deflection;</p> <p>d) Condition D: with simultaneous angular and diametric deflection.</p> <p>The applicable selection of the test pressure(s) and the test condition(s) is/are specified in the referring standard.</p> |
| Statuss | Standarts spēkā |
| ICS grupa | 23.040.20 91.140.80 |