Informējam, ka Sistēma pielāgota darbam ar interneta pārlūkprogrammu Internet Explorer (8. un jaunākām versijām) un Mozilla Firefox (3.6 un jaunākām versijām).
Izmantojot citu interneta pārlūkprogrammu, brīdinām, ka Sistēmas funkcionalitāte var tikt traucēta.
This Part of this European Standard specifies the inspection and testing of individual and serially produced pressure vessels made of steels in accordance with EN 13445-2 predominantly subject to non cyclic operation (i.e. vessels operating below 500 full equivalent pressure cycles).
Special provisions for cyclic operation are given in EN 13445-3 and in Annex G of this Part.
This Part does not give inspection and testing provisions for vessels designed using Design by Analysis - Direct Route (DBA) of Annex B of EN 13445-3:2002.
NOTE The responsibilities of parties involved in the conformity assessment procedures are given in Directive 97/23/EC. Guidance on this can be found in CR 13445-7.
Reģistrācijas numurs (WIID)
31713
Darbības sfēra
This Part of this European Standard specifies the inspection and testing of individual and serially produced pressure vessels made of steels in accordance with EN 13445-2 predominantly subject to non cyclic operation (i.e. vessels operating below 500 full equivalent pressure cycles).
Special provisions for cyclic operation are given in EN 13445-3 and in Annex G of this Part.
This Part does not give inspection and testing provisions for vessels designed using Design by Analysis - Direct Route (DBA) of Annex B of EN 13445-3:2002.
NOTE The responsibilities of parties involved in the conformity assessment procedures are given in Directive 97/23/EC. Guidance on this can be found in CR 13445-7.
