Informējam, ka Sistēma pielāgota darbam ar interneta pārlūkprogrammu Internet Explorer (8. un jaunākām versijām) un Mozilla Firefox (3.6 un jaunākām versijām).
Izmantojot citu interneta pārlūkprogrammu, brīdinām, ka Sistēmas funkcionalitāte var tikt traucēta.
This European Standard specifies requirements, assessment methods, compliance criteria and a designation system for fittings with radial and axial press ends for use with plastics and multilayer pipes. The fitting ends have a size range from 10 mm to 160 mm. The fittings are designed for a service lifetime up to fifty years
Details of applications and classes of service conditions are specified in the relevant plastics piping systems standards.
This European Standard applies to fittings made of materials listed in CEN/TS 13388.
Adaptor fittings for use with plastic and multilayer pipes may combine press ends with fitting ends defined in the other parts of EN 1254.
Press fittings for use with plastic and multilayer pipes may also have flanged end connections according to EN 1092-3.
Compression fittings for use with plastic and multilayer pipes may also have a plated or other decorative surface coating.
Products covered by this standard are intended to be used in:
a) liquid applications:
hot or cold or combined hot and cold water systems;
heating and cooling systems;
drainage systems;
sprinkler systems.
b) gas applications:
natural gas and liquefied petroleum gas systems with a maximum operating pressure less than or equal to 5 bar;
medical gases;
compressed air.
Reģistrācijas numurs (WIID)
61376
Darbības sfēra
This European Standard specifies requirements, assessment methods, compliance criteria and a designation system for fittings with radial and axial press ends for use with plastics and multilayer pipes. The fitting ends have a size range from 10 mm to 160 mm. The fittings are designed for a service lifetime up to fifty years
Details of applications and classes of service conditions are specified in the relevant plastics piping systems standards.
This European Standard applies to fittings made of materials listed in CEN/TS 13388.
Adaptor fittings for use with plastic and multilayer pipes may combine press ends with fitting ends defined in the other parts of EN 1254.
Press fittings for use with plastic and multilayer pipes may also have flanged end connections according to EN 1092-3.
Compression fittings for use with plastic and multilayer pipes may also have a plated or other decorative surface coating.
Products covered by this standard are intended to be used in:
a) liquid applications:
hot or cold or combined hot and cold water systems;
heating and cooling systems;
drainage systems;
sprinkler systems.
b) gas applications:
natural gas and liquefied petroleum gas systems with a maximum operating pressure less than or equal to 5 bar;
medical gases;
compressed air.
