Informējam, ka Sistēma pielāgota darbam ar interneta pārlūkprogrammu Internet Explorer (8. un jaunākām versijām) un Mozilla Firefox (3.6 un jaunākām versijām).
Izmantojot citu interneta pārlūkprogrammu, brīdinām, ka Sistēmas funkcionalitāte var tikt traucēta.
This document specifies the safety requirements for hydraulic and electro hydraulic control devices, including hydraulic valves and their control elements, valve combinations, control systems, pipes and hose assemblies, fittings, shut-off devices, measuring devices, filters, built-in pressure limiting and check valves in legs and rams and water spraying and dust suppression valves, as well emergency stop, start warning, locking- and control unit when used as specified by the manufacturer or his authorized representative. Excluded are pressure generators, and internal valves of legs and rams (e.g. leg bottom valves, see EN1804-2).
Some components are dealt with in other parts of this standard.
This document applies to hydraulic and electro hydraulic control devices at ambient temperatures from –10 °C to 60 °C.
This document identifies and takes into account:
- possible hazards which may be caused by the operation of hydraulic and electro hydraulic control devices;
- areas and operating conditions which may create such hazards;
- hazardous situations which may cause injury or may be damaging to health;
- hazards which may be caused by firedamp and/or combustible dusts.
This document describes methods for the reduction of these hazards.
A list of significant hazards covered appears in clause 4.
This document is applicable to all hydraulic control devices placed on the market for the first time after the date of issue of this standard.
This document does not specify any additional requirements for:
- use in particularly corrosive environments;
- hazards occurring during construction, transportation, decommissioning;
- earthquakes.
This dokument is valid for all hydraulic and electro hydraulic control unit, which will be supplied after date of issue of this standard.
Reģistrācijas numurs (WIID)
66121
Darbības sfēra
This document specifies the safety requirements for hydraulic and electro hydraulic control devices, including hydraulic valves and their control elements, valve combinations, control systems, pipes and hose assemblies, fittings, shut-off devices, measuring devices, filters, built-in pressure limiting and check valves in legs and rams and water spraying and dust suppression valves, as well emergency stop, start warning, locking- and control unit when used as specified by the manufacturer or his authorized representative. Excluded are pressure generators, and internal valves of legs and rams (e.g. leg bottom valves, see EN1804-2).
Some components are dealt with in other parts of this standard.
This document applies to hydraulic and electro hydraulic control devices at ambient temperatures from –10 °C to 60 °C.
This document identifies and takes into account:
- possible hazards which may be caused by the operation of hydraulic and electro hydraulic control devices;
- areas and operating conditions which may create such hazards;
- hazardous situations which may cause injury or may be damaging to health;
- hazards which may be caused by firedamp and/or combustible dusts.
This document describes methods for the reduction of these hazards.
A list of significant hazards covered appears in clause 4.
This document is applicable to all hydraulic control devices placed on the market for the first time after the date of issue of this standard.
This document does not specify any additional requirements for:
- use in particularly corrosive environments;
- hazards occurring during construction, transportation, decommissioning;
- earthquakes.
This dokument is valid for all hydraulic and electro hydraulic control unit, which will be supplied after date of issue of this standard.
