Informējam, ka Sistēma pielāgota darbam ar interneta pārlūkprogrammu Internet Explorer (8. un jaunākām versijām) un Mozilla Firefox (3.6 un jaunākām versijām).
Izmantojot citu interneta pārlūkprogrammu, brīdinām, ka Sistēmas funkcionalitāte var tikt traucēta.
<p>ISO 2493-2:2011 specifies procedures to measure the bending resistance of paper and paperboard.</p>
<p>ISO 2493-2:2011 is used to determine the bending moment required to deflect the free end of a 38 mm wide vertically clamped specimen by 15° when the load is applied at a bending length of 50 mm. For boards that tend to be permanently deformed if bent through 15°, the half bending angle, i.e. 7,5°, can be used. The bending resistance is expressed in terms of the bending moment and parameters set by the manufacturer of the Taber-type tester.</p>
<p>The method is primarily used for papers with a high grammage.</p>
Reģistrācijas numurs (WIID)
52429
Darbības sfēra
<p>ISO 2493-2:2011 specifies procedures to measure the bending resistance of paper and paperboard.</p>
<p>ISO 2493-2:2011 is used to determine the bending moment required to deflect the free end of a 38 mm wide vertically clamped specimen by 15° when the load is applied at a bending length of 50 mm. For boards that tend to be permanently deformed if bent through 15°, the half bending angle, i.e. 7,5°, can be used. The bending resistance is expressed in terms of the bending moment and parameters set by the manufacturer of the Taber-type tester.</p>
<p>The method is primarily used for papers with a high grammage.</p>
