Informējam, ka Sistēma pielāgota darbam ar interneta pārlūkprogrammu Internet Explorer (8. un jaunākām versijām) un Mozilla Firefox (3.6 un jaunākām versijām).
Izmantojot citu interneta pārlūkprogrammu, brīdinām, ka Sistēmas funkcionalitāte var tikt traucēta.
<p>ISO 529:2017 specifies the general dimensions of short machine taps and hand taps. These dimensions, established as functions of the thread diameter and pitch, are the following:</p>
<p>- length of thread (maximum);</p>
<p>- overall length;</p>
<p>- shank diameter and dimensions of driving square;</p>
<p>- dimensions of the connecting portion between the shank and threaded part.</p>
<p>ISO 529:2017 is applicable to taps intended for cutting the following threads:</p>
<p>a) ISO metric threads:</p>
<ul>
<li>- coarse pitch;</li>
<li>- fine pitch;</li>
</ul>
<p>b) ISO inch threads:</p>
<ul>
<li>- "Unified Coarse" series (UNC) and "Unified Fine" series (UNF);</li>
</ul>
<p>c) Inch threads, non-recommended:</p>
<ul>
<li>- "British Standard Whitworth" (BSW) and "British Standard Fine" (BSF);</li>
<li>- "British Association" (BA).</li>
</ul>
<p>NOTE 1 The overall length, thread length and diameters of shank for taps whose thread diameter and pitch are not listed in tables are given in Table A.1.</p>
<p>NOTE 2 Annex B gives an abstract from ISO 237 for shank diameters and size of driving squares, for information.</p>
<p>NOTE 3 Technical specifications for taps covered by this document (including marking) are given in ISO 8830.</p>
Reģistrācijas numurs (WIID)
69200
Darbības sfēra
<p>ISO 529:2017 specifies the general dimensions of short machine taps and hand taps. These dimensions, established as functions of the thread diameter and pitch, are the following:</p>
<p>- length of thread (maximum);</p>
<p>- overall length;</p>
<p>- shank diameter and dimensions of driving square;</p>
<p>- dimensions of the connecting portion between the shank and threaded part.</p>
<p>ISO 529:2017 is applicable to taps intended for cutting the following threads:</p>
<p>a) ISO metric threads:</p>
<ul>
<li>- coarse pitch;</li>
<li>- fine pitch;</li>
</ul>
<p>b) ISO inch threads:</p>
<ul>
<li>- "Unified Coarse" series (UNC) and "Unified Fine" series (UNF);</li>
</ul>
<p>c) Inch threads, non-recommended:</p>
<ul>
<li>- "British Standard Whitworth" (BSW) and "British Standard Fine" (BSF);</li>
<li>- "British Association" (BA).</li>
</ul>
<p>NOTE 1 The overall length, thread length and diameters of shank for taps whose thread diameter and pitch are not listed in tables are given in Table A.1.</p>
<p>NOTE 2 Annex B gives an abstract from ISO 237 for shank diameters and size of driving squares, for information.</p>
<p>NOTE 3 Technical specifications for taps covered by this document (including marking) are given in ISO 8830.</p>
