Informējam, ka Sistēma pielāgota darbam ar interneta pārlūkprogrammu Internet Explorer (8. un jaunākām versijām) un Mozilla Firefox (3.6 un jaunākām versijām).
Izmantojot citu interneta pārlūkprogrammu, brīdinām, ka Sistēmas funkcionalitāte var tikt traucēta.
<p>ISO/TS 10303-1792:2018-11 specifies the application module for
Sketch.
</p>
<p>
The following are within the scope of
ISO/TS 10303-1792:2018-11:
</p>
<ul>
<li>sketches as planar geometric constructs for use in the generation of surfaces and solids by means
of sweep operations and other operations of related types;
</li>
<li>neutral two dimensional sketches, defined in general coordinate systems;</li>
<li>positioned sketches, defined in three-dimensional model space;</li>
<li>relationships between neutral two dimensional sketches and positioned sketches defined by mappings;</li>
<li>the use of parameters and constraints to define variational sketches;
<p><small><a>NOTE </a>
the ability to constrain geometric elements of sketches is available when this module is used with the geometric constraints
module. </small></p>
</li>
<li>subsketches as partial sketches subject to special treatment;</li>
<li>geometric elements imported into the plane of a sketch but defined in terms of other model elements
lying outside that plane, used for constraining sketch elements with respect to external geometry;
</li>
<li>items within the scope of application module Geometric constraints, ISO/TS 10303-1789.</li>
</ul>
Reģistrācijas numurs (WIID)
76300
Darbības sfēra
<p>ISO/TS 10303-1792:2018-11 specifies the application module for
Sketch.
</p>
<p>
The following are within the scope of
ISO/TS 10303-1792:2018-11:
</p>
<ul>
<li>sketches as planar geometric constructs for use in the generation of surfaces and solids by means
of sweep operations and other operations of related types;
</li>
<li>neutral two dimensional sketches, defined in general coordinate systems;</li>
<li>positioned sketches, defined in three-dimensional model space;</li>
<li>relationships between neutral two dimensional sketches and positioned sketches defined by mappings;</li>
<li>the use of parameters and constraints to define variational sketches;
<p><small><a>NOTE </a>
the ability to constrain geometric elements of sketches is available when this module is used with the geometric constraints
module. </small></p>
</li>
<li>subsketches as partial sketches subject to special treatment;</li>
<li>geometric elements imported into the plane of a sketch but defined in terms of other model elements
lying outside that plane, used for constraining sketch elements with respect to external geometry;
</li>
<li>items within the scope of application module Geometric constraints, ISO/TS 10303-1789.</li>
</ul>
