CEN/TC 155
| Reģistrācijas numurs (WIID) | Projekta Nr. | Nosaukums | Statuss |
|---|---|---|---|
| 6281 | - | Plastics piping systems for renovation of underground drainage and sewerage network under pressure - Part 2: Lining with continuous pipes | Izstrādē |
| 6292 | - | Plastics piping systems for industrial applications - Polybutylene (PB), polyethylene (PE) and polypropylene (PP) - Part 3: Assessment of conformity | Izstrādē |
| 6302 | - | Plastics piping systems for industrial applications - Glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) - Below ground assembled from standard components - Part 7: Assessment of conformity | Izstrādē |
| 6278 | - | Plastics piping systems for renovation of underground gas supply networks - Part 3: Lining with close-fit pipes | Izstrādē |
| 6289 | - | Plastics piping systems for renovation of industrial pipelines - Part 6: Lining with inserted hoses | Izstrādē |
| 6297 | - | Plastics piping systems for industrial applications - Glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) - Below ground assembled from standard components - Part 2: Pipes with flexible or rigid joints | Izstrādē |
| 6294 | - | Plastics piping systems for industrial applications - Unplasticized, chlorinated and high impact poly(vinyl chloride) (PVC-U, PVC-C and PVC-HI) - Part 2: Recommended practice for installation | Izstrādē |
| 6287 | - | Plastics piping systems for renovation of industrial pipelines - Part 4: Lining with cured-in-place pipes | Izstrādē |
| 70855 | - | Plastics piping systems for soil and waste discharge (low and high temperature) within the building structure. Polypropylene with mineral modifiers (PP-MD) and polypropylene multi-layer with / without mineral modifiers (PP-MD). Specifications for pipes and the system | Izstrādē |
| 30843 | EN 13476-3:2007/prA1 | Systèmes de canalisations en plastique pour les branchements et les collecteurs d'assainissement sans pression enterrés - Systèmes de canalisations à parois structurées en poly(chlorure de vinyle) non plastifié (PVCU), polypropylène (PP) et polyéthylène (PE) - Partie 3: Spécifications pour les tubes et raccords avec une surface interne lisse et une surface externe profilée et le système, de Type B | Izstrādē |
Attēlo no 121. līdz 130. no pavisam 1495 ieraksta(-iem).