CEN/TC 249
| Reģistrācijas numurs (WIID) | Projekta Nr. | Nosaukums | Statuss |
|---|---|---|---|
| 22641 | EN ISO 4589-2:1999/A1:2006 | Kunststoffe - Bestimmung des Brennverhaltens durch den Sauerstoff-Index - Teil 2: Prüfung bei Umgebungstemperatur (ISO 4589-2:1996/Amd. 1:2005) | Atcelts |
| 22640 | EN ISO 294-1:1998/prA2 | Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding of multipurpose and bar test specimens | Izstrādē |
| 22639 | EN ISO 294-2:1998/prA2 | Plastics - Injection moulding of test specimens of thermoplastic materials - Part 2: Small tensile bars | Izstrādē |
| 22638 | LVS EN ISO 294-2:2000 /A1:2006 | Plastmasas - Termoplastisko materiālu testa paraugu spiedienliešana - 2.daļa: Mazie stiepes stieņi | Atcelts |
| 22638 | EN ISO 294-2:1998/A1:2005 | Kunststoffe - Spritzgießen von Probekörpern aus Thermoplasten - Teil 2: Kleine Zugstäbe - Änderung 1 (ISO 294-2:1996/Amd 1:2004) | Atcelts |
| 22637 | prEN ISO 294-3/prA1 | Plastics - Injection moulding of test specimens of thermoplastic materials - Part 3: Small plates | Izstrādē |
| 22636 | prEN ISO 294-4/prA1 | Plastics - Injection moulding of test specimens of thermoplastic materials - Part 4: Determination of moulding shrinkage | Izstrādē |
| 22634 | EN ISO 4613-2:1995/prA2 | Plastics - Ethylene/vinyl acetate (E/VAC) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties | Izstrādē |
| 22631 | EN ISO 8986-2:1995/prA2 | Plastics - Polybutene (PB) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties | Izstrādē |
| 22630 | prEN ISO 7822 rev | Textile glass reinforced plastics -- Determination of void content -- Loss on ignition, mechanical disintegration and statistical counting methods | Izstrādē |
Attēlo no 1361. līdz 1370. no pavisam 2317 ieraksta(-iem).